Work lamp 34 LED.

TECHNICAL CHARACTERISTICS:

          * Light yield:  340.000 mcd.
          * Time of loaded illumination:  5 Hrs.
          * Loaded time:  2,5 - 3 hours.
          * Type of ligth bulbs:  Superbright Leds.
          * Measures of LED lamp:  208 x 53 x 53 mm.
          * Lamp weigth:  0.45 Kg.
          * IP norm:  IP65
          * Reference:  4034
 

DESCRIPTION OF LED PORTABLE LAMP:

   - Reloadable profesional LED lamp.
   - Electrical intensity:
          * Entrance 230V.
          * Exit:  12 V, 1 Amp.
   - Luminous source of 180 Lux to 1 m.
   - Use temperature:  -40ºC to +40ºC
   - Protection index:  IP65
   - Battery capacity:  3.6V 4000mAh (ni-MHG 2000mAh)

Charger for the 4034 LED lamp.

   - This LED lamp of work is very versatile since it reunites to the last technology in LEDS and batteries. It has 34 LEDS of high brightness and yield with a reflector polished that increases its light intensity.
   - Its body is surrounded in rubber and the diffuser is of polycarbonate of high resistance to blows, oil, fats, water, etc...

Attachment for the 4034 LED lamp.

THIS RELOADABLE LAMP IT INCLUDES:

   - Base of charger for fixation in Mural or Table.
   - Folding universal steel hook all positions 360º.
   - Interrupting protected pressure rubber.
   - Charger of 230V it includes.
   - Indicating LED of battery two functions loads and low battery with function of automatic ignition in case of tension cut.

USE INSTRUCTIONS FOR THE LED LAMP 4034:

- Attention - important Note of security
   * If it thinks that it is not possible to be used the equipment in conditions of security, to be unplugged immediately and to make sure that it is not possible to be ignited by negligence.  The use of the equipment follows dangerous if it does not signal operation or if this visibly damaged.
   * Single the authorized personnel can carry out repairs.

Indicator of load of the battery (constant and intermittent Way). Switch ON-OFF.

  - Operation:
   * When the lamp is loaded for the first time, to load during 15 hours.
    Normally, the lamp approximately must be loaded until the green LED ignites,    (of 2 to 3 hours)

To connect the base of load to the adapter to fit to the network

  - Switch:
   * Way of ignition: To press the switch once to ignite and to extinguish again
   * Intermittent way: To maintain the switch supported during 5 seconds

To align the arrows and to slide in the base. To take and to block until the green light ignites of intermittent way. That indicates that the load has begun

  - Indications:
   * Indicator of load: The green LED blinks during the load.
   * Full load: The green LED is left ignition of permanent way
   * Debil battery: The red LED ignites.

- Automatic Ignition:
   * During the phase of load, the lamp ignites automatic in case of blackout.

When the lamp completely is loaded, the green light ignites. To screw the lamp in sense in opposition to the clock to unblock it. To remove the lamp to use it.

  - Function of protection:
   * Micro-controllers protect the battery of any overload.
   The phase of load will be stopped automatically when the lamp completely is loaded

Universal hook

  - Luminous Control:
   * The luminosity is maintained at a constant level. It offers a uniform light in any level of load of the battery

- Reset function:
    * If it is necessary, it will be used to return to a way of normal use.

RESET:  To use the conductive cable to connect the 2 points of connection. Conductive cable (not including).

  - Important information for the batery charge:
      * When the battery is recharged for the first time, or if the lamp were not used during of long time, 3 cycles are needed load/unloading so that the battery finds its full capacity again.
      * The duration of life of the battery could be reduced if the lamp is put under extreme conditions, for example, a temperature very elevated
      * If the lamp is not used during a year, so that the battery is not damaged the lamp at least once must be loaded and be unloaded.

Base of load - Arrangement to cables.

  - Guarantee:
      * The equipment has a guarantee of 12 months from the date of purchase, with the condition of which the instructions of use were followed properly.
      Tecnocem does not have obligation to offer guarantee some for defects of the product due to an abnormal use, deliberate damages, negligence, alteration or repair of the product without the approval of Caspe Elctromontajes, S.L
      * In case of problems, we are thankful to him that it directly sends the full field equipment with shipper to its local remarketer or to Caspe Electromontajes, S.L